-
Friendly, Affordable and Local
-
TT Plumbing & Heating - 24 hour
-
TT Plumbing & Heating Services for Care Homes
-
TT Plumbing & Heating - 1hr Response
-
TT Plumbing & Heating Services London
Worcester Bosch boiler broken down? We're Gas Safe registered engineers covering London and the surrounding areas, with a 1-hour emergency response target, no call-out fee, and no subscriptions or lock-in contracts. Call 07904 847 696 — 24 hours a day, 365 days a year.
24-7 TT Plumbing & Heating is a Which? Trusted Trader and our lead engineer holds the CIPHE Master Plumber certificate.
Worcester Bosch boilers show a fault code on the display when something goes wrong. These are the codes we're called out to most often, and whether it's a DIY reset or an engineer job.
| Code | What it means | Can you fix it? |
|---|---|---|
| EA / EA 229 | No flame detected — the boiler tried to light but failed | Check the gas supply is on (other gas appliances working?). Try one reset. If it recurs, call an engineer — often the gas valve, electrodes or a flue fault. |
| E9 | Overheating — safety thermostat has tripped | Engineer required. Usually poor circulation, a failed pump or a sludged system. Do not keep resetting. |
| C1 | Fan speed fault — fan not running correctly | Engineer required — fan testing and usually replacement. |
| CE / C6 | Fan or communication fault | Engineer required. |
| EF / F0 | Internal (PCB) fault | Engineer required. Often a control board fault. |
| E5 | Flow sensor over-temperature | Engineer required — sensor or circulation fault. |
| A1 | Pump running dry / low water / poor circulation | Check system pressure first. If pressure is fine, call an engineer — often a stuck pump or airlock. |
| d1 / low pressure | System water pressure has dropped too low | Often yes — repressurise via the filling loop to 1–1.5 bar. If it keeps dropping, you have a leak and need an engineer. |
| A / low water | Low water pressure warning | Repressurise as above. Persistent loss means a leak or a failed expansion vessel — engineer required. |
| 229 | Flame loss during operation | Try one reset. If it recurs, engineer required — gas supply, gas valve or condensate blockage. |
| 1602 / 1608 | Condensate or flue fault (frozen condensate common in winter) | A frozen condensate pipe is sometimes a DIY thaw, but if you're unsure, call us — it's often a same-day fix. |
Important: if your Worcester boiler locks out repeatedly, stop resetting it. Repeated resets on a boiler with an underlying fault — especially an E9 overheat or an EA ignition failure — can cause further damage and, with gas faults, are a safety risk. Call us and we'll diagnose it properly.
We repair all current and most legacy Worcester Bosch models, including the Greenstar i, Greenstar CDi Classic, Greenstar Life, Greenstar Si, Greenstar Highflow, Greenstar Heatslave (oil), and older Greenstar Ri and Junior models.
Our vans carry a substantial stock of common Worcester parts, so the majority of repairs are completed on the first visit rather than needing a return trip.
Common Worcester Bosch problems we're called out to:
• No heating or hot water
• EA / ignition lockout needing repeated resets
• E9 overheating and safety cut-outs
• Losing pressure — usually a leak or a failed expansion vessel
• Leaking from the boiler or condensate pipe
• Frozen condensate pipe (very common in cold snaps — often a same-day fix)
• Hot water running lukewarm or fluctuating (common on Greenstar combis)
• Boiler kettling, banging, or gurgling
• Radiators not heating properly
No call-out fee. You pay for the work carried out, not for us turning up. No subscriptions, no maintenance contracts — a one-off repair service for people who'd rather pay when they need us.
An annual service keeps your Worcester boiler running at its rated efficiency, catches wear before it becomes a breakdown, and protects your warranty. Worcester Bosch warranties — up to 12 years on some Greenstar models — require the boiler to be serviced annually by a Gas Safe registered engineer, with the service documented. Miss a year and you risk a declined warranty claim.
Our engineer will arrive with a Gas Safe ID card — always ask to see it, from us or anyone else working on your gas appliances. The service then covers:
• Boiler casing removed for a full internal inspection
• Heat exchanger inspected and cleaned — the most common site of scale build-up and the most expensive component to replace
• Flue gas analysis to confirm the boiler is burning correctly and operating safely
• Gas pressure and gas rate checked against Worcester's specification
• All safety controls tested — pressure relief valve, thermostat, and flame supervision
• Pipework inspected for corrosion, leakage, or poor support
• Condensate trap cleaned and the run checked for freeze risk
• System pressure and expansion vessel checked and recharged if needed
• Written service record issued for your warranty protection
Price: from £CALL — flat rate, no hidden extras. Takes around 45 minutes to an hour. Same-day and next-day appointments are usually available.
A boiler that hasn't been serviced gradually loses efficiency as the heat exchanger fouls and combustion drifts out of tolerance — and that shows up directly in your energy bills. A single failed component caught at a service — a worn pump, a sticking valve, a corroded seal — is almost always cheaper to fix than the breakdown it would have caused in the middle of January.
A Worcester boiler is one part of a system. When you've lost heating or hot water, the fault isn't always the boiler itself — it can be the pump, a motorised valve, the thermostat, a blocked heat exchanger, or sludge in the pipework restricting flow.
We diagnose the whole system rather than replacing parts speculatively. Common central heating work we carry out alongside Worcester Bosch repair:
• Radiators cold at the bottom or not heating at all
• Powerflushing to clear sludge and restore circulation
• pump and motorised valve replacement
• Thermostat and smart control installation
• Cylinder and immersion faults affecting hot water
• Leakage tracing on concealed pipework
If your Worcester boiler is beyond economic repair — a failed heat exchanger, obsolete parts, or simply age — a replacement is often the better investment. We install the full Greenstar range with free written quotations and guarantee registration.
See our Worcester Bosch boiler installation page for details, or call 07904 847 696 to discuss your options.
We cover London and the surrounding areas, with engineers based across our service area rather than dispatched from a single depot — which is how we offer a 1-hour emergency response target.
Areas we cover for Worcester Bosch repair and servicing include:
Uxbridge · Ruislip · Harrow · Hillingdon · Hayes · Northolt · Greenford · Stanmore · Edgware · Pinner · Northwood · Ickenham · West Drayton · Southall · Hounslow · Camden · Hampstead · Highgate · Islington · Kentish Town · Finchley · Muswell Hill · Crouch End · Tottenham · Willesden · Kilburn · Cricklewood · Golders Green · Hendon · Mill Hill · Paddington · Maida Vale · Notting Hill · St John's Wood
Not listed? Call us — we cover London and the Home Counties borders.
We provide Worcester Bosch servicing and CP12 Gas Safety Certificates for landlords, letting agents, and managing agents across London, fulfilling your obligations under the Gas Safety (Installation and Use) Regulations 1998. Ask about our annual reminder service for multi-property portfolios. We also cover Worcester commercial and light-commercial boilers for care homes, offices, and business premises.
How much does a Worcester Bosch boiler repair cost in London?
It depends on the fault and any parts needed. We charge no call-out fee, so you only pay for the work carried out. We give you a price before starting and won't proceed without your agreement.
How much is a Worcester Bosch boiler service?
Our standard Worcester service is £, flat rate, with no hidden extras. It takes around 45 minutes to an hour.
My Worcester boiler is showing EA — what does that mean?
EA means the boiler tried to ignite but no flame was detected. First check your gas supply is on and other gas appliances work. Try one reset. If it locks out again, stop resetting and call an engineer — it's usually the gas valve, electrodes, or a flue issue.
My Worcester boiler shows low pressure and keeps dropping — can I fix it?
You can repressurise it via the filling loop to 1–1.5 bar, but if the pressure keeps falling there's a leak in the system or a failed expansion vessel, and you'll need an engineer to trace it.
Do you service Worcester boilers to keep the warranty valid?
Yes. Worcester warranties require annual servicing by a Gas Safe registered engineer, documented — which is exactly what we provide, with a written record after every visit.
Do I need to be tied into a contract?
No. We don't sell subscriptions or maintenance plans. You call us when you need us and pay for that visit.
Can you come out today?
In most cases yes. We aim for a 1-hour response on genuine emergencies and offer same-day appointments for non-emergency work wherever possible.
Which? Trusted Trader — independently vetted and endorsed
CIPHE Master Plumber — fewer than 30 awarded in the UK
Gas Safe registered — all gas work certified
No call-out fee — you pay for the work, not the visit
No subscriptions or contracts — one-off repairs, pay as you go
1 hour emergency response target, 24/7, 365 days a year
Call 07904 847 696 or message us on WhatsApp for Worcester Bosch repair or servicing anywhere in London.
If you need help, don't hesitate to get in touch.
Gas Safe registered engineers
TT Plumbing and Heating can help with all plumbing work, including:
This is only a few examples, TTPH can help with all plumbing jobs.
